Something went wrong. Try again.
Linux kernel mirror (for testing) git.kernel.org/pub/scm/linux/kernel/git/torvalds/linux.git
Something went wrong. Try again.
123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354555657585960616263646566676869707172737475767778798081828384858687888990919293949596979899100101102103104105106107108109110111112113114115116117118119120121122123124125126127128129130131132133134135136137138139140141142143144145146147148149150151152153154155156157158159160161162163164165166167168169170171172173174175176177178179180181182183184185186187188189190191192193194195196197198199200201# SPDX-License-Identifier: GPL-2.0## Makefile for the Linux kernel device drivers.## 15 Sep 2000, Christoph Hellwig <hch@infradead.org># Rewritten to use lists instead of if-statements.#
obj-y += cache/obj-y += irqchip/obj-y += bus/
obj-y += phy/
# GPIO must come after pinctrl as gpios may need to mux pins etcobj-$(CONFIG_PINCTRL) += pinctrl/obj-$(CONFIG_GPIOLIB) += gpio/obj-y += pwm/
# LEDs must come before PCI, it is needed by NPEM driverobj-y += leds/
obj-y += pci/
obj-$(CONFIG_PARISC) += parisc/obj-$(CONFIG_RAPIDIO) += rapidio/obj-y += video/obj-y += idle/
# IPMI must come before ACPI in order to provide IPMI opregion supportobj-y += char/ipmi/
obj-$(CONFIG_ACPI) += acpi/
# PnP must come after ACPI since it will eventually need to check if acpi# was used and do nothing if soobj-$(CONFIG_PNP) += pnp/obj-y += amba/
obj-y += clk/# Many drivers will want to use DMA so this has to be made available# really early.obj-$(CONFIG_DMADEVICES) += dma/
# SOC specific infrastructure drivers.obj-y += soc/obj-$(CONFIG_PM_GENERIC_DOMAINS) += pmdomain/
obj-y += virtio/obj-$(CONFIG_VDPA) += vdpa/obj-$(CONFIG_XEN) += xen/
# regulators early, since some subsystems rely on them to initializeobj-$(CONFIG_REGULATOR) += regulator/
# reset controllers early, since gpu drivers might rely on them to initializeobj-$(CONFIG_RESET_CONTROLLER) += reset/
# tty/ comes before char/ so that the VT console is the boot-time# default.obj-y += tty/obj-y += char/
# iommu/ comes before gpu as gpu are using iommu controllersobj-y += iommu/
# gpu/ comes after char for AGP vs DRM startup and after iommuobj-y += gpu/
obj-$(CONFIG_CONNECTOR) += connector/
# i810fb depends on char/agp/obj-$(CONFIG_FB_I810) += video/fbdev/i810/
obj-$(CONFIG_PARPORT) += parport/obj-y += base/ block/ misc/ mfd/ nfc/obj-$(CONFIG_LIBNVDIMM) += nvdimm/obj-y += dax/obj-$(CONFIG_DMA_SHARED_BUFFER) += dma-buf/obj-$(CONFIG_NUBUS) += nubus/obj-y += cxl/obj-y += macintosh/obj-y += scsi/obj-y += nvme/obj-$(CONFIG_ATA) += ata/obj-$(CONFIG_TARGET_CORE) += target/obj-$(CONFIG_MTD) += mtd/obj-$(CONFIG_SPI) += spi/obj-$(CONFIG_SPMI) += spmi/obj-$(CONFIG_HSI) += hsi/obj-$(CONFIG_SLIMBUS) += slimbus/obj-y += net/obj-$(CONFIG_ATM) += atm/obj-$(CONFIG_FUSION) += message/obj-y += firewire/obj-$(CONFIG_UIO) += uio/obj-$(CONFIG_VFIO) += vfio/obj-y += cdrom/obj-y += auxdisplay/obj-$(CONFIG_PCCARD) += pcmcia/obj-$(CONFIG_DIO) += dio/obj-$(CONFIG_SBUS) += sbus/obj-$(CONFIG_ZORRO) += zorro/obj-$(CONFIG_ATA_OVER_ETH) += block/aoe/obj-$(CONFIG_TC) += tc/obj-$(CONFIG_USB_PHY) += usb/obj-$(CONFIG_USB) += usb/obj-$(CONFIG_USB_SUPPORT) += usb/obj-$(CONFIG_PCI) += usb/obj-$(CONFIG_USB_GADGET) += usb/obj-$(CONFIG_OF) += usb/obj-$(CONFIG_SERIO) += input/serio/obj-$(CONFIG_GAMEPORT) += input/gameport/obj-$(CONFIG_INPUT) += input/obj-$(CONFIG_RTC_LIB) += rtc/obj-y += i2c/ i3c/ media/obj-$(CONFIG_PPS) += pps/obj-y += ptp/obj-$(CONFIG_W1) += w1/obj-y += power/obj-$(CONFIG_HWMON) += hwmon/obj-$(CONFIG_THERMAL) += thermal/obj-$(CONFIG_WATCHDOG) += watchdog/obj-$(CONFIG_MD) += md/obj-$(CONFIG_BT) += bluetooth/obj-$(CONFIG_ACCESSIBILITY) += accessibility/obj-$(CONFIG_EDAC) += edac/obj-$(CONFIG_EISA) += eisa/obj-$(CONFIG_PM_OPP) += opp/obj-$(CONFIG_CPU_FREQ) += cpufreq/obj-$(CONFIG_CPU_IDLE) += cpuidle/obj-y += mmc/obj-y += ufs/obj-$(CONFIG_MEMSTICK) += memstick/obj-$(CONFIG_INFINIBAND) += infiniband/obj-y += firmware/obj-$(CONFIG_FWCTL) += fwctl/obj-$(CONFIG_CRYPTO) += crypto/obj-$(CONFIG_SUPERH) += sh/obj-y += clocksource/obj-$(CONFIG_DCA) += dca/obj-$(CONFIG_HID_SUPPORT) += hid/obj-$(CONFIG_PPC_PS3) += ps3/obj-$(CONFIG_OF) += of/obj-$(CONFIG_SSB) += ssb/obj-$(CONFIG_BCMA) += bcma/obj-$(CONFIG_VHOST_RING) += vhost/obj-$(CONFIG_VHOST_IOTLB) += vhost/obj-$(CONFIG_VHOST) += vhost/obj-$(CONFIG_GREYBUS) += greybus/obj-$(CONFIG_COMEDI) += comedi/obj-$(CONFIG_GPIB) += gpib/obj-$(CONFIG_STAGING) += staging/obj-y += platform/
obj-$(CONFIG_MAILBOX) += mailbox/obj-$(CONFIG_HWSPINLOCK) += hwspinlock/obj-$(CONFIG_REMOTEPROC) += remoteproc/obj-$(CONFIG_RPMSG) += rpmsg/obj-$(CONFIG_SOUNDWIRE) += soundwire/
# Virtualization driversobj-y += virt/obj-$(CONFIG_HYPERV) += hv/
obj-$(CONFIG_PM_DEVFREQ) += devfreq/obj-$(CONFIG_EXTCON) += extcon/obj-$(CONFIG_MEMORY) += memory/obj-$(CONFIG_IIO) += iio/obj-$(CONFIG_IPACK_BUS) += ipack/obj-$(CONFIG_NTB) += ntb/obj-$(CONFIG_POWERCAP) += powercap/obj-$(CONFIG_MCB) += mcb/obj-$(CONFIG_PERF_EVENTS) += perf/obj-$(CONFIG_RAS) += ras/obj-$(CONFIG_USB4) += thunderbolt/obj-$(CONFIG_CORESIGHT) += hwtracing/coresight/obj-y += hwtracing/intel_th/obj-$(CONFIG_STM) += hwtracing/stm/obj-$(CONFIG_HISI_PTT) += hwtracing/ptt/obj-y += android/obj-$(CONFIG_NVMEM) += nvmem/obj-$(CONFIG_FPGA) += fpga/obj-$(CONFIG_FSI) += fsi/obj-$(CONFIG_TEE) += tee/obj-$(CONFIG_MULTIPLEXER) += mux/obj-$(CONFIG_SIOX) += siox/obj-$(CONFIG_GNSS) += gnss/obj-$(CONFIG_INTERCONNECT) += interconnect/obj-$(CONFIG_COUNTER) += counter/obj-$(CONFIG_MOST) += most/obj-$(CONFIG_PECI) += peci/obj-$(CONFIG_HTE) += hte/obj-$(CONFIG_DRM_ACCEL) += accel/obj-$(CONFIG_CDX_BUS) += cdx/obj-$(CONFIG_DPLL) += dpll/obj-y += resctrl/
obj-$(CONFIG_DIBS) += dibs/obj-$(CONFIG_S390) += s390/