Something went wrong. Try again.
What happens if I push all of nixpkgs
Something went wrong. Try again.
Nix
123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354555657585960616263646566676869707172737475767778798081828384{ pkgs, lib, ... }:{ name = "connman"; meta = with lib.maintainers; { maintainers = [ rnhmjoj ]; };
# Router running radvd on VLAN 1 nodes.router = { ... }: { imports = [ ../modules/profiles/minimal.nix ];
virtualisation.vlans = [ 1 ];
boot.kernel.sysctl."net.ipv6.conf.all.forwarding" = true;
networking = { useDHCP = false; interfaces.eth1.ipv6.addresses = [ { address = "fd12::1"; prefixLength = 64; } ]; };
services.radvd = { enable = true; config = '' interface eth1 { AdvSendAdvert on; AdvManagedFlag on; AdvOtherConfigFlag on; prefix fd12::/64 { AdvAutonomous off; }; }; ''; }; };
# Client running connman, connected to VLAN 1 nodes.client = { ... }: { virtualisation.vlans = [ 1 ];
# add a virtual wlan interface boot.kernelModules = [ "mac80211_hwsim" ]; boot.extraModprobeConfig = '' options mac80211_hwsim radios=1 '';
# Note: the overrides are needed because the wifi is # disabled with mkVMOverride in qemu-vm.nix. services.connman.enable = lib.mkOverride 0 true; services.connman.networkInterfaceBlacklist = [ "eth0" ]; networking.wireless.enable = lib.mkOverride 0 true; networking.wireless.interfaces = [ "wlan0" ]; };
testScript = '' start_all()
with subtest("Router is ready"): router.wait_for_unit("radvd.service")
with subtest("Daemons are running"): client.wait_for_unit("wpa_supplicant-wlan0.service") client.wait_for_unit("connman.service") client.wait_until_succeeds("connmanctl state | grep -q ready")
with subtest("Wired interface is configured"): client.wait_until_succeeds("ip -6 route | grep -q fd12::/64") client.wait_until_succeeds("ping -c 1 fd12::1")
with subtest("Can set up a wireless access point"): client.succeed("connmanctl enable wifi") client.wait_until_succeeds("connmanctl tether wifi on nixos-test reproducibility | grep -q 'Enabled'") client.wait_until_succeeds("iw wlan0 info | grep -q nixos-test") '';}